Very high torque for accurately moving heavy loads.Specifications: Step angle: 1.8° Voltage (V): 8.6 Current (A): 2.0 Resistance (Ohms): 4.3 Inductance (mH): 16.2 L0 Dimension (mm): 76 L1 Dimension (mm):...
AIO MKR Barebones V2 DIY DTG Controller Board. - 48mhz SAMD21 Cortex-M0+ 32bit low power ARM MCU- 42v output to power motor driver on the Epson Power supply- Easy to plug in...
This board allows the removal of the Epson stock encoder wheel and motor. Reduces errors and noise during printing. Intended for 1440x1440 or lower resolutions that are standard for...
Optical Limit Switch kit for DIY DTG printers. This kit helps you replace the mechanical limit switch at the back of the printer. Benefits: Quiet Operation - No...
Arduino shield for OpenDTG dtg printer.Allows you to connect into the epson ribbon cables to read encoder wheel signals and also send PE sensor signal to the epson printer from...
This kit comes with everything you need to convert your Epson into a flatbed DTG printer. This kit is the same base and electronics used on our OpenDTG Basic 2...