You have no items in your shopping cart.
$899.99
This kit comes with everything you need to convert your Epson into a flatbed DTG printer. This kit is the same base and electronics used on our OpenDTG Basic 2...
Availability:
4 In Stock
This kit comes with everything you need to convert your Epson into a flatbed DTG printer.
This kit is the same base and electronics used on our OpenDTG Basic 2 Complete Printer
What's included
- Basic 2 Base Kit
- Upgraded Linear Rail system
- Magnetic Quick Swap Platen system with non slip platen top
- Ultimate DTG Controller board with Capping Station control
- Stepper Motor and wiring
- Mainboard mounting plate and hardware
- Ink Spit tray
What's not included but needed for DTG:
- Epson Printer
- Inks and consumables
- RIP Software
- One on One Tech Support. Support provided via OpenDTG forum.
Also Purchased
AIO MKR Barebones DTG Controller Board
AIO MKR Barebones V2 DIY DTG Controller Board. - 48mhz SAMD21 Cortex-M0+ 32bit low power ARM MCU- 42v output to power motor driver on the Epson Power supply- Easy to plug in...
From $69.99
Encoder Wheel Emulator for P600
This board allows the removal of the Epson stock encoder wheel and motor. Reduces errors and noise during printing. Intended for 1440x1440 or lower resolutions that are standard for...
$149.99
$99.99
Complete DIY DTG Basic Conversion Kit - Unassembled
This kit comes with everything you need to convert your Epson into a flatbed DTG printer. What's included Basic Base Kit AiO MRK Barebones DTG Controller board Stepper Motor...
$599.99
Optical Limit Switch
Optical Limit Switch kit for DIY DTG printers. This kit helps you replace the mechanical limit switch at the back of the printer. Benefits: Quiet Operation - No...
$24.99
DIY DTG Arduino Shield V2 R3000 / P600 with 2 FFC Cables
Arduino shield for OpenDTG dtg printer.Allows you to connect into the epson ribbon cables to read encoder wheel signals and also send PE sensor signal to the epson printer from...
$39.99
Smooth Idler Pulley Kit
The Kit Includes: (1) Smooth Idler Pulley – Delrin (2) Ball Bearings – 625 2RS (5mm Bore) (1) 5mm Shim (1) 1/8" Nylon Spacer (1) M5 * 25mm Low Profile...
$6.99
